how can i reduce stuck-on food when cleaning my contact grill?
if grease and stuck-on food make clean-down difficult, check the condition and fit of any approved grill sheet. a matching liner may reduce sticking without removing the normal cleaning workload.
switch off, disconnect and let the plates cool fully before inspection or cleaning. use the grill manual's method rather than sharp scrapers or abrasive pads. do not cut food on the sheet.
the linked guide is for renewing a worn matching sheet, not repairing a heater or eliminating grease-tray cleaning. six-slice sheets are 370 x 740 mm with RC6 retention; eight-slice sheets are 495 x 740 mm with RC8 retention. they are not interchangeable. respect the sheet's 260 C / 500 F maximum and any stricter grill limit. no particular cleaning-time saving is established.
first checks
- inspect the cool sheet
check wear, flat seating and the model's specified retainer while maintaining the normal plate and grease-tray cleaning routine.
solutions
diy warning
working on appliances can involve mains electricity, water and moving parts. always disconnect power and water before you start. in Australia, gas work must be done by a licensed gasfitter, and fixed (hard-wired) electrical work by a licensed electrician. everything on this site is guidance only, and any repair you carry out is at your own risk. we are not responsible for any damage or injury caused by attempting a repair. if you are not confident, please use a qualified technician.
