how to check a gas-cooktop ignition-switch problem
absent or continuous ignition clicking can involve the knob switch or another ignition component. leave the affected burner off and ask a qualified gas-appliance repairer to identify the fault.
A/401/14 is one clip-on microswitch with two attached leads and insulated connectors, not the spark generator or a complete set of burner switches.
- repair type
- technician service
- difficulty
- moderate
scope: match the complete ILVE model, including /1, /i or other suffix. the repairer must compare the switch body, clip, leads and connectors. do not remove controls or panels, or release gas to test ignition.
diy warning
working on appliances can involve mains electricity, water and moving parts. always disconnect power and water before you start. in Australia, gas work must be done by a licensed gasfitter, and fixed (hard-wired) electrical work by a licensed electrician. everything on this site is guidance only, and any repair you carry out is at your own risk. we are not responsible for any damage or injury caused by attempting a repair. if you are not confident, please use a qualified technician.
i agree, show repair advice
steps
- leave the burner off
stop trying to light the affected burner. don't release more gas to test it.
- record what stopped
note whether one or several controls stopped triggering ignition, and whether clicking disappeared or continued without lighting. record the full model and suffix from the label or paperwork without removing knobs or panels.
- arrange an ignition check
give these details to the repairer and use the product page with their identification. leave gas and electrical access, any replacement and safety checks to them.
- check after service
the repairer must confirm normal ignition and safe operation before the burner is used again.
think you can improve this guide? help us
