what does F19 mean on my Miele dishwasher?
Miele identifies dishwasher F19 as a flow-meter fault requiring technical service. it concerns measuring incoming water, but does not by itself prove that the bare sensing board needs replacing.
model scope: Miele domestic dishwashers displaying F19.
record the full model and warning, and whether water never enters or starts entering before filling stops. check only an accessible supply tap or already visible hose without moving the dishwasher or opening side panels.
the linked flow-sensing guide explains the technician's assessment. for the documented G1000/G2000 system, the technician must distinguish flow sensing from hydraulic movement and connection faults. the linked bare board is not a complete inlet chamber or sensor casing; those existing pieces must remain sound and the exact revision, clips and connector must match.
do not open panels or perform electrical tests to select a board. a technician must establish the fault and confirm controlled filling and no leaks after any repair.
possible causes
- a failed flow-sensing board
- a connection or hydraulic flow-meter problem
solutions
diy warning
working on appliances can involve mains electricity, water and moving parts. always disconnect power and water before you start. in Australia, gas work must be done by a licensed gasfitter, and fixed (hard-wired) electrical work by a licensed electrician. everything on this site is guidance only, and any repair you carry out is at your own risk. we are not responsible for any damage or injury caused by attempting a repair. if you are not confident, please use a qualified technician.
