how to identify a cased dishwasher flow sensor
the small flow-meter sensor detects incoming water; it is only one possible cause of a filling fault. have a technician check the fault before ordering.
this supply includes the sensing board and its plastic case. it is not the bare board or the large water inlet chamber on the side of the dishwasher.
- repair type
- technician service
- difficulty
- moderate
scope: use the complete model and revision and compare the old case and connector. saved references 00611317, 611317 and 10016522 identify the linked supply, not every appliance with a filling warning.
diy warning
working on appliances can involve mains electricity, water and moving parts. always disconnect power and water before you start. in Australia, gas work must be done by a licensed gasfitter, and fixed (hard-wired) electrical work by a licensed electrician. everything on this site is guidance only, and any repair you carry out is at your own risk. we are not responsible for any damage or injury caused by attempting a repair. if you are not confident, please use a qualified technician.
i agree, show repair advice
steps
- check the visible supply
check the accessible tap and any already-visible hose for a sharp bend. don't pull the dishwasher out. note whether water enters before it stops and whether water remained from the last wash.
- arrange a sensor check
give a qualified technician the complete appliance label and filling details. leave the cabinet panels and electrical connections closed.
- confirm the sensor
if it has failed, use every appliance revision digit in the product page compatibility checker. have the technician compare the case and connector, then fit it under the model's service instructions.
- check after repair
the technician must confirm normal filling with no leaks before the dishwasher is used again.
think you can improve this guide? help us
parts for this solution
related problems
- what does E14 mean on my Bosch dishwasher?E14 can involve flow detection or another filling problem. check only accessible supply items before arranging diagnosis.
- why does my dishwasher stop while it is filling?record whether water starts entering or never enters. supply restrictions and flow-sensing faults need to be distinguished before parts are ordered.
