how to check and clean a dishwasher microfine filter cone
food caught in an intact microfine filter may only need rinsing away. replace damaged mesh or a cracked cone, but first confirm that the retained handle and flat plate are sound.
the 4011464 / 04011464-style supply is the lower cone only. its yellow latch opens the cleaning flap; it does not separate the cone from the handle.
- repair type
- mechanical repair
- difficulty
- moderate
scope: Miele's G600/G800 technical-manual example, section 5.23, describes removing the old snap joint, aligning the replacement and pressing it onto the handle. this is not a universal method; get help if the exact connection is unclear or brittle.
diy warning
working on appliances can involve mains electricity, water and moving parts. always disconnect power and water before you start. in Australia, gas work must be done by a licensed gasfitter, and fixed (hard-wired) electrical work by a licensed electrician. everything on this site is guidance only, and any repair you carry out is at your own risk. we are not responsible for any damage or injury caused by attempting a repair. if you are not confident, please use a qualified technician.
i agree, show repair advice
steps
- cool and inspect the filter
switch off and let the dishwasher cool. use its care instructions to remove and rinse the filter. look for torn mesh, a cracked cone or a deteriorating handle; watch for sharp debris.
- use the cleaning flap correctly
the yellow latch opens the flap for cleaning; it does not release the cone from its handle. rinse trapped food from an intact cone and compare its shape, tabs and handle connection before choosing any replacement.
- refit sound parts or arrange the correct repair
refit an intact filter combination flat and securely locked under the exact model instructions. a damaged cone needs its model-specific handle-joint procedure; get a repairer if that connection is unclear or brittle. do not run with loose or missing filter pieces.
think you can improve this guide? help us
