how to identify a five-rib dryer drive belt
a running motor with a stationary drum can indicate a belt problem, but the motor, tensioner, pulleys and drum supports also need checking. do not keep running the dryer to investigate.
D511255P-style supply is one belt with five ribs and four grooves, about 2380 mm around, 8 mm wide and 3 mm thick, for one drum.
- repair type
- technician service
- difficulty
- moderate
scope: use the dryer-section identity on stacked units. Kleenmaid LEK37/LGK37 requires qualified tool-assisted disassembly; gas work needs suitable service. the belt route must come from the exact model instructions.
diy warning
working on appliances can involve mains electricity, water and moving parts. always disconnect power and water before you start. in Australia, gas work must be done by a licensed gasfitter, and fixed (hard-wired) electrical work by a licensed electrician. everything on this site is guidance only, and any repair you carry out is at your own risk. we are not responsible for any damage or injury caused by attempting a repair. if you are not confident, please use a qualified technician.
i agree, show repair advice
steps
- stop the dryer
switch off, let it cool and disconnect power safely. do not keep running a drum that will not turn, reach into a running dryer or bypass the door switch.
- record the model
note the lack of movement already seen. check the full model on the product page. on a stacked unit, use the dryer-section identity, not just the washer label.
- have the drive checked
ask a qualified technician to check the belt, motor, pulleys, tensioner and drum supports. they should compare the old belt reference and ribs before fitting, and follow the exact belt route. stacked access and any gas work need suitable service arrangements.
- have the drum checked
the technician should check that the drum turns normally with the cabinet fully reassembled before the dryer returns to use.
think you can improve this guide? help us
