how to replace a dryer condenser sponge filter
clean an intact condenser sponge as the dryer manual directs; replace foam that is torn, deteriorated or still blocked after cleaning. the H0180300116-compatible pack contains two separate sponges, each about 245 x 140 x 10 mm.
fit one in the original support and keep the other as a spare. a damaged support is a separate repair.
- repair type
- owner care
- difficulty
- easy
- hands-on time
- ~ 10 min
scope: match the full dryer revision, foam outline and locating holes. on DH8060P3, cln lint is a cleaning prompt, not proof that the foam needs replacement. avoid the sharp fins behind the filter.
steps
- check the cool filter
switch off, unplug and let the dryer cool. check for tears, crumbling or blockage left after the recommended cleaning. check the full model and revision on the product page, plus the foam's outline and holes.
- remove the old foam
open the condenser-filter cover and release the support as the manual directs. remove the damaged foam and clear accessible lint. keep fingers away from the sharp fins behind it.
- fit one sponge
lay one sponge flat in the support without gaps. refit and secure the support and cover. never run the dryer without the filter.
- check the cover
check that the support and cover close securely. arrange service if a cleaning prompt continues after the filter has been cleaned and refitted as instructed.
diy warning
working on appliances can involve mains electricity, water and moving parts. always disconnect power and water before you start. in Australia, gas work must be done by a licensed gasfitter, and fixed (hard-wired) electrical work by a licensed electrician. everything on this site is guidance only, and any repair you carry out is at your own risk. we are not responsible for any damage or injury caused by attempting a repair. if you are not confident, please use a qualified technician.
think you can improve this guide? help us
