how to use time dry for a small load in a Westinghouse vented dryer
on Westinghouse WDV556N3WB and WDV656N3WB dryers, use a suitable time dry programme for a small tumble-dryable load that remains damp after autosensing. airing 30 is unheated; clean the lint filter and let the cooling stage finish.
- repair type
- owner care
- difficulty
- easy
- hands-on time
- ~ 5 min
scope: Westinghouse WDV556N3WB and WDV656N3WB vented dryers.
when to get help
- stop for a burning smell, unusual cabinet heat or poor drying across normal loads despite clean filters and an unobstructed visible vent.
steps
- check the programme and fabric label
airing 30 uses no heat. for tumble-dryable items still damp after autosensing, choose a time dry programme suited to the load in the model's programme table.
- check the load before restarting
clean the lint filter with power off and refit it. separate thick items and leave room for tumbling. do not select extra dry for heat-sensitive fabric just to force a longer run.
- let the cooling stage finish
check the result after the timed cycle and cooling stage. if you must stop a hot cycle early, remove and spread out all items promptly so trapped heat can escape.
diy warning
working on appliances can involve mains electricity, water and moving parts. always disconnect power and water before you start. in Australia, gas work must be done by a licensed gasfitter, and fixed (hard-wired) electrical work by a licensed electrician. everything on this site is guidance only, and any repair you carry out is at your own risk. we are not responsible for any damage or injury caused by attempting a repair. if you are not confident, please use a qualified technician.
think you can improve this guide? help us
