how to check an integrated fridge's door slide rails
the slide rails link an integrated fridge's appliance door to its kitchen cabinet door through separate brackets. replace cracked or worn rails only after checking that the brackets and hinges remain sound.
the linked two- and four-packs contain white rails about 320 x 30 mm. brackets and fixings are not included.
- repair type
- mechanical repair
- difficulty
- moderate
scope: count the rails actually needing repair. keep the original layout and use the exact appliance integration instructions; diagram measurements are not universal drilling positions. stop forcing a binding door and get help with support or alignment.
diy warning
working on appliances can involve mains electricity, water and moving parts. always disconnect power and water before you start. in Australia, gas work must be done by a licensed gasfitter, and fixed (hard-wired) electrical work by a licensed electrician. everything on this site is guidance only, and any repair you carry out is at your own risk. we are not responsible for any damage or injury caused by attempting a repair. if you are not confident, please use a qualified technician.
i agree, show repair advice
steps
- check the damaged rails
look for splits or wear without loosening the cabinet door. check the full model, rail profile and attachment points on the product page. count the rails needing replacement rather than using the pack size to decide.
- check the supports
check that brackets and hinges are undamaged. don't keep forcing a door that binds or hangs loose.
- arrange supported fitting
have the rails fitted in the original layout under the appliance's integration instructions, with the door safely supported. get an installer if support or alignment is uncertain.
- check both doors
check that each rail slides through its bracket and both doors move together and close freely. stop if they pull against each other, a bracket shifts or the cabinet door needs realignment.
think you can improve this guide? help us
