how to identify a closed-loop oven door seal
compare a damaged oven seal with the full model and fixing layout before ordering. Beko 455930002 is one black closed-loop gasket with metal retaining hooks.
a door that sits unevenly needs a separate alignment check; a new seal alone may not address it.
- repair type
- technician service
- difficulty
- moderate
scope: 90 cm describes appliance width. applications replacing 455935001 or 455930005 still need model and fixing confirmation. Euromaid GE90S requires an authorised service person. do not reshape the rubber or move hooks to other holes.
diy warning
working on appliances can involve mains electricity, water and moving parts. always disconnect power and water before you start. in Australia, gas work must be done by a licensed gasfitter, and fixed (hard-wired) electrical work by a licensed electrician. everything on this site is guidance only, and any repair you carry out is at your own risk. we are not responsible for any damage or injury caused by attempting a repair. if you are not confident, please use a qualified technician.
i agree, show repair advice
steps
- look at the cold seal
with the oven off and cold, photograph the loop, corners and fixing points without removing it. check the full model in the compatibility checker; another old part reference does not replace the model and mounting checks.
- leave the seal alone
keep the oven off and cold. do not reshape the rubber or pull a loose hook into another hole.
- arrange the right help
give the repairer the model and photos. check the exact model's instructions before seal removal or door handling. GE90S instructions require an authorised service person.
- have the seal fitted
ask the repairer to check the door alignment and the area where the seal sits. the loop should sit evenly without twists or forced hooks, and the door should close normally. an uneven door needs separate attention.
think you can improve this guide? help us
