how to replace a motorised vacuum floor head
replace a physically damaged motorised head once you have confirmed the exact appliance and connector. if only the roller has stopped, try the vacuum manual's accessible cleaning checks first.
Bosch 17004665 is a complete head with housing, brush roller and connection neck, not the vacuum's main motor.
- repair type
- owner care
- difficulty
- easy
- hands-on time
- ~ 2 min
scope: switch off and disconnect charging before handling the head. keep the full e-nr slash revision; ProAnimal or Athlet alone does not establish interchangeability. do not open the head's electrical parts.
steps
- switch the vacuum off
switch the vacuum off and disconnect charging. check for cracks, worn wheels or a damaged connection. follow its care instructions for visible hair or blockages if the head is otherwise intact.
- check the full model
read the full e-nr, including its slash revision, from the model label. use the product page compatibility checker and compare the head and tube connector; the range name alone isn't enough.
- change the head
with the vacuum off and disconnected from charging, use the release catch to remove the old head. secure the new head without forcing it.
- check before use
check that the head locks in place and moves normally before using the assembled vacuum. if it won't lock or the brush still won't turn, switch off and ask for model-specific help.
diy warning
working on appliances can involve mains electricity, water and moving parts. always disconnect power and water before you start. in Australia, gas work must be done by a licensed gasfitter, and fixed (hard-wired) electrical work by a licensed electrician. everything on this site is guidance only, and any repair you carry out is at your own risk. we are not responsible for any damage or injury caused by attempting a repair. if you are not confident, please use a qualified technician.
think you can improve this guide? help us
