how to check water supply after an Electrolux washer shows E10 or E11
for the Electrolux front-loading washers and washer-dryers covered by the E10/E11 filling guidance, check the tap and safely visible inlet hose. only clean a connection or inlet screen where the model's manual permits it, with power and water isolated.
- repair type
- owner care
- difficulty
- moderate
- hands-on time
- ~ 15 min
scope: Electrolux front-loading washers and washer-dryers covered by the E10/E11 filling guidance.
when to get help
- for a leak or damaged connection, close the tap and arrange repair. get help if the hose cannot be reached safely.
steps
- check the tap and hose
pause the machine. check that the supply tap is open and the visible hose is not kinked, trapped or damaged. do not pull the machine out to reach it.
- check the inlet-cleaning instructions
if your manual allows hose or inlet-screen cleaning, switch off, isolate power and close the tap before following that procedure. leave inaccessible connections alone.
- get help if the warning returns
after any permitted cleaning, refit the connections and restore the supply as the manual directs. if E10 or E11 returns, arrange service and report the code and model. do not open internal panels or valve wiring.
diy warning
working on appliances can involve mains electricity, water and moving parts. always disconnect power and water before you start. in Australia, gas work must be done by a licensed gasfitter, and fixed (hard-wired) electrical work by a licensed electrician. everything on this site is guidance only, and any repair you carry out is at your own risk. we are not responsible for any damage or injury caused by attempting a repair. if you are not confident, please use a qualified technician.
think you can improve this guide? help us
