why is foam left after rinsing in my Haier HWF75AW1 or HWF85AW1?
excess detergent or a high-foaming product can prolong rinsing and leave foam after spin in HWF75AW1 and HWF85AW1 washers. the detergent must also suit the selected programme.
model scope: Haier HWF75AW1 and HWF85AW1 front loaders.
let the washer complete its safe rinse sequence; do not force a hot or locked door or add more detergent to cure foam. for future loads, use low-foaming front-loader detergent at the packet's appropriate dose, not an invented universal amount.
the linked guide covers compartment 1 for prewash and the main-wash compartment for ordinary programmes. these two models do not use liquid detergent with prewash or delay selected. after stopping and unplugging, clean accessible drawer residue only as instructed. do not mix chemicals to remove suds. escaping foam or water, failed drainage or continuing trouble with correct dosing needs help.
first checks
- check the selected detergent and programme
read the pack dose and drawer guidance before the next load; do not open a locked drum or add chemicals during active foaming.
possible causes
- excess detergent or a product unsuitable for front loaders
- detergent type does not suit the selected prewash or delay programme
solutions
diy warning
working on appliances can involve mains electricity, water and moving parts. always disconnect power and water before you start. in Australia, gas work must be done by a licensed gasfitter, and fixed (hard-wired) electrical work by a licensed electrician. everything on this site is guidance only, and any repair you carry out is at your own risk. we are not responsible for any damage or injury caused by attempting a repair. if you are not confident, please use a qualified technician.
