why will my Apuro CR836-A or DR825-A commercial blender not start?
an Apuro CR836-A or DR825-A may not start if the jug is not seated correctly. the version 4 manual starts with safe jug and visible-condition checks, not a motor diagnosis.
model scope: Apuro CR836-A and DR825-A, version 4 manual.
switch off, unplug and wait for the blades to stop. look for leaks, jug or lid damage, loose blades or a damaged lead. with the switch off, seat the dry jug squarely and secure the lid and its plug as the exact manual shows.
the linked checking guide permits normal operation only after the assembly is dry, sound and correctly fitted. its cleaning method excludes soaking and dishwashing the jug; keep water out of the motor base.
continued failure to start needs service. do not open the base or bypass safety devices. earlier and later manual editions conflict on hot liquids, so do not assume the shared model codes establish hot-liquid permission for your particular unit and jug.
possible causes
- the jug is not seated correctly.
- the switch is off or power is unavailable.
- a damaged power lead that needs service.
solutions
diy warning
working on appliances can involve mains electricity, water and moving parts. always disconnect power and water before you start. in Australia, gas work must be done by a licensed gasfitter, and fixed (hard-wired) electrical work by a licensed electrician. everything on this site is guidance only, and any repair you carry out is at your own risk. we are not responsible for any damage or injury caused by attempting a repair. if you are not confident, please use a qualified technician.
