why is water left in my Fisher & Paykel DS605 or DD605 DishDrawer?
excess water across a DS605 or DD605 tub can follow blocked filters or a kinked drain hose. on these drawers, correct drain-filter seating and a flat, locked filter plate also matter.
model scope: Fisher & Paykel DS605 and DD605 DishDrawers.
let the drawer and retained water cool, then switch power off safely before the permitted care. the small drain filter should sit flush with the plate. if the plate needs cleaning, follow the 605 manual's locking-ring sequence and keep clear of sharp edges.
the linked guide applies only to DS605 and DD605, not ninth-series filter arrangements. inspect a hose only where already visible; do not pull out the appliance or remove cabinetry. water outside the drawer, damaged fittings or continued failure to drain needs service. never reach through pooled water to an electrical connection.
first checks
- use the 605 instructions
confirm DS605 or DD605, cool and switch off, then check the filter using that manual's method rather than a newer-family guide.
possible causes
- blocked drain filter or filter plate
- bent or kinked drain hose
solutions
diy warning
working on appliances can involve mains electricity, water and moving parts. always disconnect power and water before you start. in Australia, gas work must be done by a licensed gasfitter, and fixed (hard-wired) electrical work by a licensed electrician. everything on this site is guidance only, and any repair you carry out is at your own risk. we are not responsible for any damage or injury caused by attempting a repair. if you are not confident, please use a qualified technician.
