why does my Electrolux EDH913R9WB keep turning after drying ends?
an EDH913R9WB can continue anti-crease tumbling for about 30 minutes after drying, or longer with extra anticrease. filter and tank lights can also remain as end-of-load reminders.
model scope: Electrolux EDH913R9WB heat-pump dryer.
confirm that drying has actually ended rather than assuming every continuing movement or heating fault is anti-crease. the linked guide explains deactivating the dryer with its on/off button before unloading; the finished load can be removed before this phase ends.
unplug before the specified lint-filter and tank care. this manual calls for removing lint dry by hand or vacuum, not washing that filter with water. empty the collection container if used. continued abnormal heating, burning smells, a fault warning or persistently damp loads need assessment. these details belong to EDH913R9WB, not all Electrolux heat-pump dryers or filter designs.
first checks
- check the phase and reminders
read the completed programme and selected extra anticrease option before switching off to unload.
possible causes
- normal end-of-programme anti-crease phase
- extra anticrease option was selected
solutions
diy warning
working on appliances can involve mains electricity, water and moving parts. always disconnect power and water before you start. in Australia, gas work must be done by a licensed gasfitter, and fixed (hard-wired) electrical work by a licensed electrician. everything on this site is guidance only, and any repair you carry out is at your own risk. we are not responsible for any damage or injury caused by attempting a repair. if you are not confident, please use a qualified technician.
