how to check end-of-cycle tumbling on an Electrolux EDH913R9WB dryer
on the Electrolux EDH913R9WB dryer, check whether drying has finished and anti-crease tumbling is continuing. switch off before removing the finished load, then unplug for the specified dry lint-filter care and tank emptying.
- repair type
- owner care
- difficulty
- easy
- hands-on time
- ~ 5 min
scope: Electrolux EDH913R9WB only.
when to get help
- get help for continued heating outside the normal phase, a fault warning, burning smells or damp loads that do not improve with the permitted care.
steps
- check whether drying has ended
look for the completed programme and anti-crease phase. extra anticrease extends that phase, so continued drum movement after drying does not by itself mean the timer is stuck.
- remove the finished load
you may remove the laundry before the anti-crease phase finishes. use the on/off button to deactivate the dryer, open the door and take the clothes out.
- do the end-of-load care
with the dryer unplugged, remove lint from the filter by hand or vacuum, not water. empty the collection container if used. filter and tank lights at the end can be reminders, not proof of failed parts.
diy warning
working on appliances can involve mains electricity, water and moving parts. always disconnect power and water before you start. in Australia, gas work must be done by a licensed gasfitter, and fixed (hard-wired) electrical work by a licensed electrician. everything on this site is guidance only, and any repair you carry out is at your own risk. we are not responsible for any damage or injury caused by attempting a repair. if you are not confident, please use a qualified technician.
think you can improve this guide? help us
