when should i replace a torn or misshapen dryer plinth filter?
foam behind the lower dryer flap needs replacement if it is torn, distorted or still blocked after recommended cleaning. a dirty intact filter may only need care, not replacement.
unplug the dryer and let it cool before permitted filter access. check the shaped corner, thickness and handle holes for the exact model. gaps around the foam can let lint pass towards the heat exchanger.
the linked guide covers 12551630-compatible foam for an existing sound handle and holder. the two-pack is for alternating filters while one dries, not stacking two at once. do not refit dripping-wet foam, reach into sharp fins or run without the filter. if correct cleaning and refitting do not clear a warning, seek service rather than simply clearing the reminder or repeatedly buying foam.
first checks
- inspect after normal cleaning
look for tears, distortion and poor seating, and check that the holder and flap remain sound.
solutions
diy warning
working on appliances can involve mains electricity, water and moving parts. always disconnect power and water before you start. in Australia, gas work must be done by a licensed gasfitter, and fixed (hard-wired) electrical work by a licensed electrician. everything on this site is guidance only, and any repair you carry out is at your own risk. we are not responsible for any damage or injury caused by attempting a repair. if you are not confident, please use a qualified technician.
