how to replace a dryer plinth foam filter
clean and inspect the plinth foam before replacing it. torn, distorted or persistently blocked foam can leave gaps or restrict airflow.
the 12551630-compatible pack contains two washable foam filters, about 205 x 153 x 30 mm each. fit one to the sound existing handle and holder; keep the other as a spare while one dries.
- repair type
- owner care
- difficulty
- easy
- hands-on time
- ~ 5 min
scope: compare the shaped corner, thickness and handle holes. unplug and cool before access. follow the model's drying instructions, avoid the sharp heat-exchanger fins and never run without the filter.
steps
- unplug and cool the dryer
unplug the dryer and let it cool. inspect for tears, distortion or gaps after the recommended cleaning. check the full model and compare the shaped corner, thickness and handle holes.
- remove the old foam
open the lower flap as instructed and pull out the filter by its handle. remove the worn foam and wipe accessible lint from the handle.
- fit one filter
fit one foam element the right way round without stretching it. seat it fully and close the flap. don't refit dripping-wet foam, reach into the sharp fins or run without the filter.
- check the fit
the foam must sit closely and the flap must close normally. warnings that continue after the recommended care need service.
diy warning
working on appliances can involve mains electricity, water and moving parts. always disconnect power and water before you start. in Australia, gas work must be done by a licensed gasfitter, and fixed (hard-wired) electrical work by a licensed electrician. everything on this site is guidance only, and any repair you carry out is at your own risk. we are not responsible for any damage or injury caused by attempting a repair. if you are not confident, please use a qualified technician.
think you can improve this guide? help us
parts for this solution
related problems
- why does my Miele TWD660WP dryer stop with F066?clean the model's door and plinth filters first. damaged or uncleanable foam may need replacement, but recurring warnings can have other causes.
- why does my Miele TWV780WP say 'Clean the fluff filter. Check the airways.'?this cancellation message differs from a routine end-of-cycle reminder. follow the model's filter care and leave deeper restrictions for assessment.
- when should i replace a torn or misshapen dryer plinth filter?inspect the cleaned foam for tears, distortion and gaps. fit one replacement element, not both filters in the pack.
