how to open a Bosch WVH28490AU washer-dryer after drying
on the Bosch WVH28490AU washer-dryer, a small amount of residual moisture can reach a small finished load when the door opens quickly. wait for normal unlocking and open slowly; this does not explain wash-stage leaks or water left in the drum.
- repair type
- owner care
- difficulty
- easy
- hands-on time
- ~ 5 min
scope: Bosch WVH28490AU only; a small amount of water on opening after drying, not an active wash leak.
when to get help
- arrange service for pooling, wash-stage leakage or persistent drainage trouble. do not force the lock, open electrical covers or treat every leak as condensation.
steps
- wait for the normal release
let the programme finish and wait for the door lock to release. open the door slowly rather than pulling it open quickly; this reduces the suction effect described in the guide.
- check whether the symptom fits
the guide describes a small amount of residual moisture after a shorter drying run with a small load. repeated wet laundry, water in the drum or water escaping during washing needs separate checking.
- keep drying loads within their limit
the drying limit is lower than the washing limit on this model. use the programme table and split a full wash into suitable drying loads rather than overloading the drying phase.
diy warning
working on appliances can involve mains electricity, water and moving parts. always disconnect power and water before you start. in Australia, gas work must be done by a licensed gasfitter, and fixed (hard-wired) electrical work by a licensed electrician. everything on this site is guidance only, and any repair you carry out is at your own risk. we are not responsible for any damage or injury caused by attempting a repair. if you are not confident, please use a qualified technician.
think you can improve this guide? help us
