how to clean the lint filters on a Samsung WD90H19AHSSA washer-dryer
on the Samsung Bespoke AI laundry combo WD90H19AHSSA, switch off and cool the appliance before removing the inner and outer lint filters. clear lint, rinse both layers and dry them completely in the shade before reassembling after each drying load.
- repair type
- owner care
- difficulty
- easy
- hands-on time
- ~ 10 min
scope: Samsung Bespoke AI laundry combo WD90H19AHSSA only.
when to get help
- do not use wet or damaged filters. get help if the assembly will not seat or drying remains poor after the specified care.
steps
- remove both filter layers gently
after the drying cycle finishes, switch off and let the appliance cool. open the lint-filter cover, pull out the assembly and open the outer filter to remove the inner one. do not force the hinges.
- clear lint and dry thoroughly
remove lint from both filters, rinse under running water and leave them in the shade until completely dry. do not shake or tap them to dislodge lint.
- reassemble in the right direction
fit the inner filter into the outer filter as shown in the model guide, then return the assembly to its slot. do this after each drying load rather than waiting for poor performance.
diy warning
working on appliances can involve mains electricity, water and moving parts. always disconnect power and water before you start. in Australia, gas work must be done by a licensed gasfitter, and fixed (hard-wired) electrical work by a licensed electrician. everything on this site is guidance only, and any repair you carry out is at your own risk. we are not responsible for any damage or injury caused by attempting a repair. if you are not confident, please use a qualified technician.
think you can improve this guide? help us
