why does my Simpson top-loading washing machine show E10?
on the eight documented Simpson top loaders, E10 covers both failure to fill and loss of water during washing. an inlet restriction is only one possibility.
model scope: Simpson SWT8043, SWT9043, SWT8063E, SWT1043, SWT9043A, SWT1023A, SWT1154DCWA and SWT1254LCWA top-load washing machines.
this scope is SWT8043, SWT9043, SWT8063E, SWT1043, SWT9043A, SWT1023A, SWT1154DCWA and SWT1254LCWA. check both supply taps and visible hoses without moving the connected washer or disconnecting a hose for a live flow test.
an incorrectly arranged drain hose may let water escape, so compare its visible position with the exact installation guide. if water reaches the floor, stop use, close both taps and unplug only from a dry safe point.
the linked cold-valve assessment is relevant only after service distinguishes supply, drainage, leakage and internal fill faults. the triple cold assembly is separate from the hot valve; E10 does not select it. record whether one or both supplies are affected, and give the full model and product number to the repairer before matching a valve.
possible causes
- restricted supply or inlet screens
- water escaping through the drain arrangement
- a leak or an internal filling fault
solutions
diy warning
working on appliances can involve mains electricity, water and moving parts. always disconnect power and water before you start. in Australia, gas work must be done by a licensed gasfitter, and fixed (hard-wired) electrical work by a licensed electrician. everything on this site is guidance only, and any repair you carry out is at your own risk. we are not responsible for any damage or injury caused by attempting a repair. if you are not confident, please use a qualified technician.
