how to replace a top-loader agitator wing nut
if the agitator is loose, check whether its retaining wing nut is missing, cracked or no longer gripping. a matching nut can help only when the agitator and its attachment are sound.
425059 is the earlier white plastic wing-nut fastener; it is not the later 420665 hex-head type. the agitator and shaft are not included.
- repair type
- owner care
- difficulty
- easy
- hands-on time
- ~ 10 min
scope: unplug and wait for all movement to stop before accessing the cap or softener dispenser as the manual permits. match the product code and old fastener, not the year alone.
steps
- unplug the washer
unplug the washer and wait until it has stopped. follow the model's instructions to remove the cap or softener dispenser and inspect the nut.
- check the fastener
check the full model and product-code restrictions on the product page. 425059 differs from the later 420665 hex-head type; don't choose by year or appearance alone.
- fit the wing nut
check that the agitator and its attachment are undamaged and seated properly. fit the nut by hand and tighten it snugly without forcing it.
- refit the cap
refit the cap or dispenser before use. the agitator must stay secure. stop and get repair help if the nut slips, won't grip or leaves the agitator loose.
diy warning
working on appliances can involve mains electricity, water and moving parts. always disconnect power and water before you start. in Australia, gas work must be done by a licensed gasfitter, and fixed (hard-wired) electrical work by a licensed electrician. everything on this site is guidance only, and any repair you carry out is at your own risk. we are not responsible for any damage or injury caused by attempting a repair. if you are not confident, please use a qualified technician.
think you can improve this guide? help us
