how to prepare a washer-dryer load for drying
check the washer-dryer's drying capacity before starting; it may be lower than the wash limit. split an oversized load, choose a fabric-suitable spin and follow the model's ventilation, water-supply and owner-accessible filter requirements.
- repair type
- owner care
- difficulty
- easy
- hands-on time
- ~ 10 min
when to get help
- if a correctly prepared load still stays wet or drying will not start, arrange service and report the programme and load used.
steps
- split the load if needed
check the selected drying programme's limit. remove some items if the washed load exceeds it, and select a fabric-suitable spin before drying.
- check air and water requirements
keep the ventilation openings identified in the manual clear. leave the water tap open during drying if the machine needs water for cooling or fluff cleaning; do not assume every washer-dryer uses the same cooling method.
- follow any filter-cleaning instructions
if the manual lists a filter for regular cleaning, stop the machine, let it cool and isolate power before cleaning it by that method. do not open the cabinet to look for a filter.
diy warning
working on appliances can involve mains electricity, water and moving parts. always disconnect power and water before you start. in Australia, gas work must be done by a licensed gasfitter, and fixed (hard-wired) electrical work by a licensed electrician. everything on this site is guidance only, and any repair you carry out is at your own risk. we are not responsible for any damage or injury caused by attempting a repair. if you are not confident, please use a qualified technician.
think you can improve this guide? help us
